C Style Flex-Flex Couplings
The C Style coupling includes two flex hubs, one sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Style coupling include one flex hub, a single rigid hub, one sleeve, a single accessory kit consisting of seals and snap rings.
Features
Uncomplicated and cheap type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Available as vertical and horizontal couplings
Broad selection of specific variations for example full-flex, flex-rigid mill motor
Typical configurations are available from the shelf
Ordering Details
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Data
Puller Holes are standard on sizes four by twelve.
Puller Holes can be found for sizes 7/8 by three.five at an additional charge.
The BSE (distance Involving Shaft Ends) may well differ in between G and G1.
Interference bores without set screws are standard unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Segment.
Greater sizes are available, please seek advice from Technical Help.