Electrical power UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is built exclusively for that small lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has become extensively used while in the sector of logistic devices for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed from the solenoid valve together with the speed controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
General Description
This energy unit is created exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the speed managed from the adjustable needle valve. Once the lift rises to a high positoin, however the electrical power provide is lower, the lowering movement is controlled from the manual override perform.
Power UNITS FOR LIFT TABLE 3
Standard Description
This power unit is designed exclusively for your huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the speed controlled by a strain compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
General Description
This energy unit is built solely for your massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as speed managed by the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is minimize, the reducing motion is managed through the guide override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic elements concerned ahead of set up of the power unit.
three. Viscosity on the oil shoud be 15~46 cst,which must also be clean and free of charge of impurities.N46 hydraulic oil is advised.
four. Oil altering is required soon after the original one hundred operation hours,afterwards after each and every 3000 hours.
5. The electrical power unit shown is built to be mounted vertically.